remove comment referencing non-working use case ns-3.6
authorCraig Dowell <craigdo@ee.washington.edu>
Wed, 21 Oct 2009 00:17:14 -0700
changeset 5444d55c479666ac
parent 5443 0c8d1f5e0ffa
child 5445 2abe024e7099
remove comment referencing non-working use case
examples/tap/tap-wifi-dumbbell.cc
     1.1 --- a/examples/tap/tap-wifi-dumbbell.cc	Mon Oct 19 20:55:52 2009 -0700
     1.2 +++ b/examples/tap/tap-wifi-dumbbell.cc	Wed Oct 21 00:17:14 2009 -0700
     1.3 @@ -81,17 +81,7 @@
     1.4  //    sudo route add -net 10.1.3.0 netmask 255.255.255.0 dev thetap gw 10.1.1.2
     1.5  //    ping 10.1.3.4
     1.6  //
     1.7 -// 4) Try to run this in UseLocal mode.  This allows you to provide an existing
     1.8 -//    pre-configured tap device to the simulation.  The IP address and MAC 
     1.9 -//    address in this mode do not have to match those of the ns-3 device.
    1.10 -//
    1.11 -//    sudo tunctl -t mytap
    1.12 -//    sudo ifconfig mytap hw ether 08:00:2e:00:00:01
    1.13 -//    sudo ifconfig mytap 10.1.1.1 netmask 255.255.255.0 up
    1.14 -//    ./waf --run "tap-wifi-dumbbell --mode=UseLocal --tapName=mytap"&
    1.15 -//    ping 10.1.1.3
    1.16 -//
    1.17 -// 5) Try to run this in UseBridge mode.  This allows you to bridge an ns-3
    1.18 +// 4) Try to run this in UseBridge mode.  This allows you to bridge an ns-3
    1.19  //    simulation to an existing pre-configured bridge.  This uses tap devices
    1.20  //    just for illustration, you can create your own bridge if you want.
    1.21  //